teeny tiny small parts

[Paul]

How do you sand down the small tiny parts that are impossible to hold between your fingers. That escapes me just as much as seeing said same parts.

[LyleW]

The obvious, smart alec comment would be, "Very Carefully!"

I usually try to hit them as best as I can while they are on the tree. That, or pinch them between fingers and have a go at it.

[Stikpusher]

If you're talking about the mold seam lines on those parts, I usually do that while they are still on the sprue using needle files. I clean up the sprue attachment point usually after the part is glued in place if need be. I have tried using tweezers to hold small parts, but this often results in the small part being launched into oblivion...

[59North]

There is a small 1/72nd gun-sight still attached to a sprue piece held in the clamp. I'll then put a thin abrasive stick to good use:

[Paul]

Alright! Hemostats, I have not thought about getting any of those. Great idea.

[59North]

Alright! Hemostats, I have not thought about getting any of those. Great idea.

Glad you like it; but, us red-necks just call them clamps.

[Paul]

Alright! Hemostats, I have not thought about getting any of those. Great idea.

Glad you like it; but, us red-necks just call them clamps.

and us old stoners called them something else...

[tigrazor]

Tweezers!

Invest 1-2 $ more, and you should find a good one.

[BlackSheep214]

Locking tweezers also comes to mind.....