I feel lost.

[scorpiomikey]

I'm sitting at my bench with a model at 80% and a looming deadline. I've been away nearly two weeks and I feel lost. I know what needs to be done but I'm having a hard time doing it. Lol. I just don't know where to start. I'm going to have to figure it out I guess. Normally I'd probably just whip out a new kit and start fresh. Not doing that. Have the F-4 on the go but I can't resume it until the one on my bench is complete. I've got five days to get it figured out. Yay me. Haha.

How do you eat an elephant? One bite at a time.
Pick a spot, do something, move on to something else small until you get into the swing of things.

[mostrich]

Start with some "stupid" work like sanding, masking etc.
While doing it you'll slip back into da funk.

[nathant]

Ahh, the classic 80% syndrome. You just got back from vacation. Don't model right away. take a day or 2 off, then you'll feel the urge to start again...hopefully within 5 days though..

[VanceCrozier]

Ahh, the classic 80% syndrome. You just got back from vacation. Don't model right away. take a day or 2 off, then you'll feel the urge to start again...hopefully within 5 days though..

~guilty~

[lawman56]

I feel your pain, Jim. I finally had a day this past weekend where I wasn't working on the yard, house, car, etc... Sat down at the bench and stared. First at one project, then another, then another. Took most of the day to actually start to do something. Mostly because I couldn't remember my train of thought at the time I had stopped. Once I did start, the time flew and I had to put it all aside again.

Oh well.

[Tojo72]

We all go thru down times,work and chores have cut down the bench time for me,and it's hard to get started again.

[Fermis]

Being away from the bench is a killer of motivation to be at the bench.
With work in full swing, I barely get any bench time...and when I do get a bit of free time...I just can't "get into it" at the bench, even though it's all I think about when I'm away from the bench.

Is it December yet???